Sharp AR-C150 Service Manual page 109

Code
Function (Purpose)
Main Sub
46 19 Used to adjust the copy density (gamma).
(Monochrome/Map
mode)(AR-C150/C250/C160/C270)
20 Used to adjust the copy density (gamma).
(Color/ All modes) (The copy color balances
(gamma) in all copy modes are changed.)
The operations are the same as SIM 46-21,
but printing is not performed.
21 Used to adjust the copy color balance
(gamma). (Color/All modes) (The color
balance (gamma) in all the copy modes is
changed. Printing is performed while
adjustment.
22 Used to make the print (printer engine) color
balance (gamma) adjustment. (Auto
adjustment) (AR-C100)
23 Used to the half tone high density correction
operation. (AR-C150/C250/C160/C270)
24 Used to adjust the print (printer engine) color
balance (gamma). (Auto adjustment) (For
AR-C150/C250/C160/C270)
25 Used to adjust the copy color balance.
(Single color copy mode)
(AR-C250/C160/C270)
26 Used to set the copy color balance
adjustment value to the default. (Single color
copy mode) (AR-C250/C160/C270)
27 Used to adjust the black toner component
image gamma. (Adjustment of the
reproduction capability of black characters
and lines) (AR-C250/C160/C270)
48 1 Used to adjust the copy magnification ratio
(main scan, sub scan direction).
6 Used to adjust each motor rotating speed.
49 1 Used to revise the version of the body
firmware. (AR-C150/C250/C160/C270)
2 Used to set the data communication speed in
version up of the body firmware.
(AR-C150/C250/C160/C270)
50 1 Used to adjust the copy image position and
the void area (image loss) on print paper in
the copy mode. (The similar adjustment can
be made also by SIM 50-2 (Simple method).)
2 Used to adjust the copy image position and
the void area (image loss) on print paper in
the copy mode.(Simple method) (The same
content of SIM 50-1. However this simulation
is easier to perform.)
10 Used to adjust the print image center
position. (Adjusted separately for each paper
feed section.)
12 Used to adjust the print image center
position. (Adjusted separately for each
document mode.)
20 Used to adjust color registration in the main
scan direction. (Manual adjustment)
21 Used to adjust the sub scan direction color
registration. (Manual adjustment)
22 Used to adjust the color registration (in the
main/sub scanning direction).
The color registration adjustment (automatic
adjustment) can be performed both in the
main and the sub scanning directions at the
same time. (AR-C250) (New version of
AR-C150) (AR-C160) (Auto adjustment)
51 1 Used to adjust the transfer operation and ON
timing of the transfer section separation pawl.
Purpose
Adjustment ICU
Adjustment ICU
Adjustment ICU
Adjustment ICU
Setting ICU
Adjustment ICU
Adjustment ICU
Setting ICU
Adjustment ICU
Adjustment
Adjustment
Other ICU
Setting ICU
Adjustment
Adjustment
Adjustment ICU
Adjustment ICU
Adjustment ICU
Adjustment ICU
Adjustment ICU
Adjustment Image process
(Photoconductor/
Developing/Transfer/
Cleaning)
8 – 9
Section
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Operation
Software
Operation
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Picture quality
Copy Operation
Item
Density
Color balance
Color balance
Color balance
Density
Color balance
Color balance
Color balance
Density
Image size/
Magnification
Image position
Image position
Image position
Image position
Image position
Image position
Image position