Sharp AR-C150 Service Manual page 118

Note Never set to another value than the specified value (de-
fault). (Otherwise, a trouble may occur.)
43 - 7
Purpose Adjustment
Function Used to adjust the fusing oil supply amount. (Adjust-
(Purpose) ment of oil motor ON time and oil motor ON interval)
Section Fixing (Fusing)
Item Operation
Operation/ 1. Select the adjustment item with [↑], [↓] keys.
Procedure
A: ON-TIME
Fusing oil pump ON time [ms]
B: CTRL-CYCLE
Fusing oil pump control cycle [ms]
2. Enter the set value with the 10-key.
3. Press the [OK] key.
When the [EXECUTE] key is pressed, it is highlighted and the
pump is operated with the set content.
When the [EXECUTE] key is pressed again, the display returns
to the normal display and the pump is stopped.
Range [ms]
ON-TIME 5 – 50
CTRL-CYCLE 17 – 250
(Example) When ON-TIME is 12ms and CTRL-CYCLE is 250ms,
12ms of ON and (250+50) – 12ms of OFF are re-
peated.
Default
A: ON-TIME
B: CTRL-CYCLE
When installing (replacing) this pump, set the pump operation
value of Sim 43-7 referring to the marking color shown in the illus-
tration below.
Default value
12
130
12 [ms]
130 [ms]
Marking color
Blue
Red
None
44
44 - 4
Purpose Setting
Function Used to set the target image (reference) density level in
(Purpose) correction (process correction) operations in the image
forming section.
Section Image process (Photoconductor/Developing/Transfer/
Cleaning)
Item Picture quality
Operation/ 1. Select the adjustment item with [↑], [↓] keys.
Procedure
2. Enter the set value with 10-key.
(255 levels)
3. Press the [OK] key. (The value entered in procedure 2 is set.)
Default value
Color sensor adjustment
reference level
Black sensor adjustment
reference level
Yellow reference density
level
Magenta reference
density level
Cyan reference density
level
Black reference density
level
Black reference density
level
8 – 18
Marking
Setting of simulation 43-7
A B
12 80
12 180
12 130
Density
PCS_C_TARGET_ID 102
PCS_B_TARGET_ID 133
Y_PAT_TARGET_ID 90
M_PAT_TARGET_ID 100
C_PAT_TARGET_ID 83
K_PAT_TARGET_ID 15
(AR-C100/C150)
K_PAT_TARGET_ID 22
(AR-C250/C160/
C270)