Ip Rtconfig - THOMSON TG605s Cli Reference Manual

ip rtconfig

Modify a route of the routing table.
SYNTAX:
ip rtconfig
where:
dst
dstmsk
label
gateway
intf
srcintf
static
status
metric
530
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <{None|DSCP|Interactive|Management|
Video|VoIP-RTP|VoIP-Signal|default}>]
[gateway = <ip-address>]
[intf = <{loop|ipsec0|lan1|wan1|dmz1|guest1}>]
[srcintf = <{loop|ipsec0|lan1|wan1|dmz1|
guest1|None}>]
[static = <{disabled|enabled}>]
[status = <{down|up}>]
[metric = <number{0-255}>]
The destination IP address(es) using this route.
Supports ip/mask notation.
The destination IP address mask.
The name of a label.
The IP address of the next hop (direct connected
gateway or extended route)
Only for special interface routes : the outgoing IP
interface name.
Use this interface for source address selection.
Route persistency: static or dynamic (note that
not all routes can be changed).
The administrative state of the route.
The metric for this route (weight factor).
ip Commands
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20080409-0002 v2.0