Eth Filter Operand Config - THOMSON TG605s Cli Reference Manual

eth filter operand config

Set the operand to a certain type (will reset content first).
SYNTAX:
eth filter operand config
where:
operand
type
operator
protocollevel
length
mask
value
daclass
frameclass
ipprotocol
action
326
operand = <{}>
type = <{CheckDAClass|CheckFrameClass|
CheckVLANPriority|CheckVID|CheckIPProto|
CheckSize|Match|Modify|CheckCheckSum|
UpdateCheckSum}>
operator = <{Equal|Less|LessEqual|InSet}>
protocollevel = <{EthernetFrame|Protocol|
EthernetPayload|ULPHeader|ULPPayload}>
length = <number>
mask = <string>
value = <string>
daclass = <{Unicast|Multicast|Broadcast}>
[frameclass = <{Eth2|SNAPEType|SNAP8021H|
SNAPOther|LLCNLPID|LLCOther}>]
[ipprotocol = <number{0-254}>]
action = <{Delete|Insert|Modify}>
offset = <number>
[priority = <number{0-7}>]
size = <number>
[vid = <number{1-4095}>]
protocol = <{IP|UpperLayer}>
The name of an operand.
The type to set.
The compare operator.
The protocol level from where to start offset/size
calculations.
The length of the compare value/mask
combination in bytes..
The mask to be used on the value.
The value.
The destination address class.
The Ethernet frame class to filter on.
The IP protocol to filter on.
The action to undertake with matching filter..
eth Commands
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
REQUIRED
E-DOC-CTC-20080409-0002 v2.0