Olivetti d-Copia 1600 Service Manual page 29

5. Remove the two screws and open the power
source PWB in the direction indicated by the
arrow.
Take care not to open the power source
PWB too much.
6. Fit the wire of the drawer heater into the
groove of the frame and put it inside the
power source PWB.
Fit the wire into the groove so that the band
mounted to the wire is located above the
frame.
7. Reattach the power source PWB to its origi-
nal position and connect the connector of
the drawer heater to YC8 of the power
source PWB.
8. Refit all the removed parts.
Wire of the drawer heater
Band
Figure 1-2-9
Connector
Figure 1-2-10
2HA/2HB
Power source PWB
YC8
1-2-9