Olivetti d-Copia 1600 Service Manual page 143

8. Loop the outer ends of the scanner wires around the outer grooves in the pulleys on the mirror 2 frame,
winding from below to above. ....................................................................................................................... (1)
9. Hook the round terminals onto the catches inside the scanner unit. ............................................................ (2)
10. Loop the inner ends of the scanner wires around the grooves in the pulleys at the left of the scanner unit,
winding from below to above. ....................................................................................................................... (3)
11. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from
above to below. ............................................................................................................................................. (4)
12. Wind the scanner wires around the grooves in the scanner wire guides at the left of the scanner unit. ...... (5)
13. Hook the round terminals onto the scanner tension springs. ........................................................................ (6)
14. Remove the scanner wire stoppers and
frame securing tools.
15. Gather the scanner wires toward the locat-
ing balls.
16. Move the mirror 2 frame from side to side to
correctly locate the wires in position.
17. Put the mirror 1 frame on the scanner rail
and move it toward the left side of the
machine.
18. Insert the frame securing tools into the posi-
tioning holes (leftmost holes) at the front and
the rear of the scanner unit and screw the
mirror 1 frame while securing both the mirror
1 frame and the mirror 2 frame.
19. Remove the two frame securing tools.
20. Refit all the removed parts.
Figure 1-5-36
Frame securing tool
Frame securing tool
Mirror 2 frame
Mirror 1 frame
Figure 1-5-37
2HA/2HB
1-5-17