Olivetti d-Copia 1600 Service Manual page 107

Problem
(16) Broken registration switch
A paper jam in the or exit switch actuator.
exit section is indi-
Defective registration
cated during copying
switch or exit switch.
(misfeed in the exit
section).
Jam code 50
Check if the registration
motor malfunctions.
Electrical problem with the
registration motor.
(17) Broken feedshift switch
A paper jam in the actuator.
feedshift section is
Defective feedshift switch.
indicated during
copying (misfeed in
the feedshift section).
Jam code 52, 53, 54,
Check if the exit motor mal-
55, 56
functions.
Electrical problem with the
exit motor.
(18) Broken feedshift switch
A paper jam in the actuator.
duplex section is indi-
Defective feedshift switch.
cated during copying
(misfeed in duplex
paper conveying sec-
tion).
Broken duplex paper con-
Jam code 60
veying switch actuator.
Defective duplex paper con-
veying switch.
Check if the exit motor mal-
functions.
Electrical problem with the
exit motor.
Check if the duplex feed
clutch malfunctions.
Electrical problem with the
duplex feed clutch.
Causes/check procedures Corrective measures
Check visually and replace the registration switch or exit switch if
its actuator is broken.
Run maintenance item U031 and turn each switch on and off
manually. Replace the corresponding switch if indication of switch
is not light.
Run maintenance item U030 and select the registration motor to
be turned on and off. Check the status and remedy if necessary.
Check (see page 1-4-26).
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn feedshift switch on and off
manually. Replace feedshift switch if indication of switch is not
light.
Run maintenance item U030 and select the exit motor to be
turned on and off. Check the status and remedy if necessary.
Check (see page 1-4-26).
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn feedshift switch on and off
manually. Replace feedshift switch if indication of switch is not
light.
Check visually and replace the duplex paper conveying switch if
its actuator is broken.
Run maintenance item U031 and turn duplex paper conveying
switch on and off manually. Replace duplex paper conveying
switch if indication of switch is not light.
Run maintenance item U030 and select the exit motor to be
turned on and off. Check the status and remedy if necessary.
Check (see page 1-4-26).
Check visually and remedy if necessary.
Check.
2HA/2HB
1-4-11