Treadmill Belt Cleaning; Procedure - Precor Energy Series Service Manual

Hide thumbs Also See for Energy Series:

Table of Contents

Treadmill Belt Cleaning

First, check for proper operation of the safety stop key. Stand to one side of the treadmill.

Insure that the stop key is hanging straight down from the stop key and is not wrapped

around the handle bars. Push the "Quick Start" button and wait for the display to count down

and for the running belt to begin moving. Once the running belt is moving pull the safety stop

key.

CAUTION

If the running belt does not stop, turn off the power using the ON/ OFF

switch at the front of the treadmill and unplug the power cord. The

treadmill must remain out of service until the stop switch is repaired.

If the running belt stops, continue with the cleaning procedure

.A clean, dry towel approximately 36 inches (1 meter) in length is required.

Fold the towel in half lengthwise, lift the running belt up and insert the towel beneath the belt

so that an end of towel extends on to each deck trim.

Stand to one side of the treadmill, push the "Quick Start" button, and grasp the towel as

shown in the illustration above. Note: You will have 3 seconds to firmly grasp your hands on

the towel before the treadmill running belt begins to move. Allow the treadmill to run for about

one minute while holding the towel firmly in place.

CAUTION

If the towel becomes loose it may be pulled into the treadmill rollers. Pull the

safety key to stop the treadmill and retrieve the towel, no damage should

occur. Start the procedure over again.

Keep one hand firmly grasped on the towel, use your other hand to pull on the safety stop key

to stop the treadmill running belt.

Turn the power off. Place your hands on the towel and push it up and down the length of the

running deck several times to clean the deck.

15Page 15 of 54

Table of Contents

200-14