Interlogix IFS WMC303-1W-1T-1200 User Manual page 88

Dual band wireless access point
Hide thumbs Also See for IFS WMC303-1W-1T-1200:
Table of Contents

Advertisement

Band
Mode
SSID
Channel Width
Control Sideband
Channel Number
Broadcast SSID
Data Rate
in a region other than one of those specified in this field. If your country
or region is not listed, please contact your local government agency for
assistance.
Select the desired mode. Default is "2.4GHz (B+G+N)". It is strongly
recommended that you set the Band to "2.4GHz (B+G+N)", and all of
802.11b, 802.11g, and 802.11n wireless stations can connect to the
WMC303-1200.
 2.4 GHz (B): 802.11b mode, rate is up to 11Mbps
 2.4 GHz (G): 802.11g mode, rate is up to 54Mbps
 2.4 GHz (N): 802.11n mode, rate is up to 300Mbps(2T2R)
 2.4 GHz (B+G): 802.11b/g mode, rate is up to 11Mbps or 54Mbps
 2.4 GHz (G+N): 802.11g/n mode, rate is up to 54Mbps or 300Mbps
 2.4 GHz (B+G+N): 802.11b/g/n mode, rate is up to 11Mbps,
54Mbps, or 300Mbps
There are four kinds of wireless mode selections:
AP
Client
WDS
AP+WDS
If you select WDS or AP+WDS, please click "WDS Settings" submenu
for the related configuration. Furthermore, click the "Multiple AP"
button to enable multiple SSID function.
The ID of the wireless network. User can access the wireless network
via the ID only. However, if you switch to Client Mode, this field
becomes the SSID of the AP you want to connect with.
Default: IFS AP 2G
You can select 20MHz, or 40MHz
You can select Upper or Lower.
You can select the operating frequency of wireless network.
If you enable "Broadcast SSID", every wireless station located within
the coverage of the WMC303-1200 can discover its signal easily. If you
are building a public wireless network, enabling this feature is
recommended. In private network, disabling "Broadcast SSID" can
provide better wireless network security.
Default is "Enabled".
Set the wireless data transfer rate to a certain value. Since most of
wireless devices will negotiate with each other and pick a proper data
transfer rate automatically, it's not necessary to change this value
unless you know what will happen after modification.
Default is "Auto".
-74-

Advertisement

Table of Contents
loading

Table of Contents