Table of Contents
Advertisement
Data Rate
Enable Mac Clone
(Single Ethernet Client)
Example of how to configure Client Mode. Please take the following steps:
To configure each wireless parameter, please go to the "WLAN1 (5GHz) → Basic Settings" page.
Step 1. Go to "WLAN1 (5GHz) → Site Survey" page and click "Site Survey" button.
Step 2. Choose the root AP from the list. If the root AP is not listed in the table, re-click "Site Survey" to update
the list.
Default is "Enabled".
Set the wireless data transfer rate to a certain value. Since most of
wireless devices will negotiate with each other and pick a proper data
transfer rate automatically, it's not necessary to change this value
unless you know what will happen after modification.
Default is "Auto".
Enable Mac Clone.
Figure 5-27 Client – Survey
-38-
Advertisement
Table of Contents
