Table of Contents
Advertisement
3.1 System Requirements
Broadband Internet Access Service (Cable/xDSL/Ethernet connection)
One IEEE 802.3at PoE switch (supply power to the WMC303-1200)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ-45 connectors
PCs running Windows 98/ME, NT4.0, 2000/XP, Windows Vista / Win 7, MAC OS 9 or later, Linux,
UNIX or other platforms compatible with TCP/IP protocols
1. The AP in the following instructions refers to IFS WMC303-1200.
2. It is recommended to use Internet Explorer 7.0 or above to access the AP.
3.2 Installing the AP
Before installing the AP, make sure your PoE switch is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
AP according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
Step 1. Drill the outlet hole indicated on the mounting label and stick the given mounting label to the installation
location to let the Ethernet cable penetrate the outlet hole. Then, drill the mounting holes as indicated
on the label.
Step 2. Take the mounting bracket, put it on the target place by aligning the holes and fix it with the supplied
Chapter 3. Connecting to the AP
Figure 3-1 WMC303-1200 Installation Diagram 1
-12-
Advertisement
Table of Contents
