3.
Open a command prompt, type ping 192.168.0.253 and then press Enter.
If the result displayed is similar to
has been established well.
If the result displayed is similar to
has failed.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your AP. Some
firewall software programs may block a DHCP request on newly installed adapters.
Figure
4-3, it means the connection between your PC and the AP
Figure 4-3 Successful result of Ping command
Figure
4-4, it means the connection between your PC and the AP
Figure 4-4 Failed Result of Ping Command
-17-