Table of Contents
Advertisement
The page includes the following fields:
Object
Enable WDS
MAC Address
Data Rate
Comment
Set Security
Show Statics
Current WDS AP List
WDS feature can only be implemented between 2 wireless devices that both support the WDS
feature. Plus, channel, security settings and security key must be the same on both such
devices.
To encrypt your wireless network, click "Set Security". For the detail of wireless security, see
section
5.3.3. Do remember to reboot the device after you save your wireless security settings;
otherwise, the WDS feature may not function.
Figure 5-40 WDS – Set Security
Check the box to enable the WDS function. Please select WDS or
AP+WDS in the Mode of Wireless Basic Settings before you enable
WDS on this page.
You can enter the MAC address of the AP you want to connect with.
Default is "Auto".
You can make some comment for each MAC address on the list.
Click the "Set Security" button to configure the wireless security
parameters of the AP you want to connect via WDS.
Click the "Show Statics" button to show the WDS AP.
You can select some MAC addresses of the AP and click the "Delete
Selected" button to delete it.
-53-
Description
Advertisement
Table of Contents
