Installing The Swingarm - Yamaha 2009 YFM25RY Service Manual

EAS23380

INSTALLING THE SWINGARM

1. Lubricate:
• Bearings
• Spacer
• Oil seals
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1"
• Spacer "2"
• Oil seals
• Dust covers
TIP
Inject the bearing with the character stamp
turned outward.
Installed depth of bearing "a"
1–2 mm (0.04–0.08 in)
3. Install:
• Pivot shaft
Pivot shaft nut
100 Nm (10.0 m·kg, 74 ft·lb)
4. Install:
• Rear shock absorber assembly
• Rear axle hub
• Rear wheel
Refer to "REAR SHOCK ABSORBER
ASSEMBLY" on page 4-51 and "REAR
AXLE AND REAR AXLE HUB" on page
4-11.
5. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE
CHAIN SLACK" on page 3-21.
Drive chain slack
45–55 mm (1.77–2.17 in)
4-56
SWINGARM