Honeywell KMH 880 Manuals

Table of Contents

• 7

  Table of Contents
• 15

  General Information
• 15

  Introduction
• 16

  System Description
• 16

  Basic EGPWS System
• 16

  Table 1-1 KMH 880/KTA 870 Applicable Versions
• 17

  Basic TAS System
  • 17

    System Components
  • 18

    KMH 880 SYSTEM PRIMARY Lrus
  • 18

    KTA 870 SYSTEM PRIMARY Lrus
    • 18

      Table 1-2 KMH 880 Lrus
    • 18

      Table 1-3 KTA 870 Lrus
    • 20

      Figure 1-1 KMH 880/KTA 870 System
    • 21

      GPS Sensor
    • 21

      Setup Mode
    • 21

      Standby Mode
    • 21

      TAS Modes of Operation
    • 22

      Altitude Monitor Option
    • 22

      Display Option
    • 22

      TAS Operation (Traffic Advisory) Mode
    • 22

      TAS Processor
  • 20

    EGPWS Modes of Operation
  • 20

    EGPWS System
  • 20

    Optional Alerting and Warning Parameters
• 23

  Technical Characteristics
  • 23

    Outside Air Temperature (OAT) (Recommended)
  • 23

    KMH 820 W/O GPS Multi-Hazard Awareness Unit Technical Specifications
  • 24

    KMH 820 W/ GPS Multi-Hazard Awareness Unit Technical Specification
• 24

  Table 1-6 KTA 810 Traffic Advisory Unit Technical Specifications
• 25

  Table 1-7 KCM 805 Configuration Module Technical Specifications
• 25

  Table 1-8 KA 815 Traffic Antenna Technical Specifications
• 26

  Unit and Accessories Supplied
  • 26

    TAS Processor Unit
  • 26

    KMH 820/KTA 810 Processor Units
• 26

  Table 1-9 KA 92 GPS Antenna Technical Specifications
• 27

  Table 1-11 KCM 805 Configuration Module
• 27

  Table 1-12 KA 815/KA 92 Antennas
• 28

  Installation Accessories Supplied
• 28

  KMH 820/KTA 810 Installation Kit
• 28

  Table 1-13 GPS Cable Run Lengths
• 29

  Antenna Installation Kits
• 29

  Table 1-14 KMH 820/KTA 810 Installation Kit
• 29

  Table 1-15 KA 815 Installation Kit
• 29

  Table 1-16 KA 92 Installation Kit
• 30

  Accessories Required but Not Supplied
• 30

  Databases
• 30

  GPS Antenna Splitter
• 30

  Table 1-18 Temperature Probe
• 31

  License Requirements
• 31

  Table 1-19 GPS Antenna Splitter
• 31

  Table 1-20 Miscellaneous Accessories
• 31

  Table 1-21 Cable and Wire
• 32

  Instructions for Continued Airworthiness
  • 32

    KMH 820/KTA 810 Unit
  • 32

    Annunciators/Relays
  • 32

    GPS Antenna
  • 33

    Wires and Coax Cables
  • 33

    Terrain Data Base Updates
  • 33

    Temperature Probe
  • 35

    Installation
  • 35

    Unpacking and Inspecting Equipment
  • 35

    Equipment Installation
• 35

  Introduction
• 36

  Avionics Cooling Requirements
• 37

  Processor Installation
  • 37

    Cooling Considerations
  • 37

    Installation Considerations
• 39

  Installation Procedure
  • 45

    Configuration Module Installation
  • 49

    Antenna Location
  • 49

    Directional Antenna Installation
  • 51

    KA 815 Antenna Outline Drawing
  • 53

    Gps Antenna Installation
  • 53

    KA 92 Antenna Installation Considerations
  • 62

    TAS Coaxial Cable Fabrication
  • 63

    GPS Coaxial Cable Fabrication
  • 63

    Signal Loss
  • 64

    Bulkhead/In-Line Connection RG-400 Coax Cable
  • 64

    Coax Cable Treatment
  • 64

    Standard RG-400 Coax Cable
  • 65

    TNC Antenna Coax/Connector Assembly
  • 67

    Applicable Part Numbers Sub-Section Description
  • 67

    Function Sub-Section Description
  • 67

    Requirements and Limitations Sub-Section Description
  • 67

    System Planning
  • 68

    Interface Subsection Description
  • 69

    Figure 3-1 KMH 880/KTA 870 Interconnect Family
  • 71

    General Interconnect Information
  • 71

    On Discrete
  • 71

    Power Inputs
  • 72

    Air/Ground Discrete Input
  • 72

    Landing Gear Discrete Input
  • 73

    Above/Below/Normal Input
  • 73

    Advisory Inhibit Input
  • 73

    Baro Altitude (ARINC 429) Input
  • 74

    Synthesized Voice Output
  • 74

    TAS Valid Output
  • 74

    Visual Annunciate Traffic (Lamp Output)
  • 75

    Air Temperature Input
  • 75

    GPS Input
  • 76

    Factory Test Input
  • 76

    TAS ATE Enable Input
  • 76

    TAS Built in Test Equipment (BITE)
  • 77

    EGPWS Self Test Input
  • 77

    Failure Categories
  • 77

    Failure Processing
  • 78

    Display Select Input
  • 78

    Terrain Awareness Inhibit Discrete
  • 78

    Terrain Caution
  • 78

    Terrain Warning
  • 79

    EGPWS Audio on Discrete
  • 79

    EGPWS, Terrain Inop and Terrain Not Available Output
    • 81

      Figure 3-2 KMH 820/KTA 810 Pinout Diagram
    • 95

      Figure 3-3 KMH 820/KTA 810 System Interconnect Block Diagram
    • 99

      Figure 3-4 KMH 820/KTA 810 Power Interface
    • 101

      Figure 3-5 KMH 820/KTA 810 Discrete Interface
    • 103

      Figure 3-6 KMH 820/KTA 810 Configuration Module Interconnect
    • 105

      Figure 3-7 KMH 820/KTA 810 Attitude/Heading Interface
    • 107

      Figure 3-8 KMH 820/KTA 810 Radar/Barometric Altitude Interface
    • 115

      Figure 3-9 KMH 820/KTA 810 Antenna/Suppression Interface
    • 119

      Figure 3-11 KMH 820/KTA 810 GC 362A Interface
    • 135

      Figure 3-14 KMH 820/KTA 810 Honeywell Primus 1000 Interface
    • 139

      Figure 3-15 KMH 820/KTA 810 Honeywell SPZ-805 Interface
    • 143

      Figure 3-16 KMH 820/KTA 810 Diagnostic/Data Recorder Interface
    • 145

      Figure 3-17 KMH 820/KTA 810 TAS ATE Interface
    • 147

      Figure 3-18 KMH 820/KTA 810 CP 66B Interface
    • 149

      Figure 3-19 KMH 820/KTA 810 KFS 578A Interface
    • 205

      Figure 3-22 KMH 820/KTA 810 Processor Front Connector
    • 206

      Figure 3-23 KMH 820/KTA 810 Front Connector Cable
    • 207

      Figure 3-24 KMH 820/KTA 810 Rear Connector Cable
    • 208

      KMH 820/KTA 810 Connector Pin Assignment
    • 211

      Certification
    • 211

      Certification Procedure
    • 211

      Equipment Compatibility
    • 211

      Equipment Location
    • 212

      FAA Form 337
    • 212

      FAA Requirements
    • 212

      Federal Communication Commission Rules
    • 212

      TSO Category
    • 213

      Flight Manual Revision
    • 213

      Pilot Briefing
    • 215

      Operation
    • 219

      Mode C Surveillance Range
    • 219

      Mode C Surveillance Range Ontop Antenna
    • 227

      Sample Certification Checklist
    • 230

      Diagnostic Appendices
    • 230

      TASDIAG-TAS Processor Field Diagnotic Program User Instructions
    • 231

      Table of Contents
    • 233

      Computer Requirements
    • 233

      Introduction
    • 234

      Installing the TAS Diag Program
    • 234

      Starting TAS Diag
    • 235

      Main Window
    • 236

      Inspecting Current Processor I/O Data
    • 236

      TAS Diag. Demonstration Mode
    • 237

      Continous View
    • 237

      Inspecting TAS Unit's Internal Diagnostic and Log Data
    • 237

      Snapshot View
    • 238

      Configuration Module Options
    • 238

      Diagnostic and Log Data Window
    • 239

      Modify Strap Data
    • 239

      View Strap Data
    • 240

      Modify Straps Window
    • 241

      Copy from Binary File
    • 241

      Save to Binary File
    • 241

      Save to Text File
    • 242

      Bore Sight Top/Bottom Antenna
    • 242

      Initialize Config Module
    • 243

      Intruder Data
    • 243

      Intruder Data Window
    • 244

      Overwrite View
    • 245

      Capture View
    • 245

      Viewing Cable Calibration Data
    • 246

      Cable Calibration Data Window
    • 246

      Viewing Current System Status
    • 247

      System Status Window
    • 247

      TAS S/W Info
    • 248

      Ramp Tester Mode
    • 248

      TAS S/W Window
    • 249

      Suggestions and Hints
    • 249

      TAS Diag Doesn't Communicate with TAS Unit
    • 251

      KTA Fault Codes
    • 277

      General
    • 278

      Limitations
    • 279

      Emergency Procedures
    • 280

      Normal Procedures
    • 280

      Preamble
    • 280

      System Activation
    • 281

      GA-EGPWS Function
    • 281

      Indicators and Controls
    • 283

      Alert Priorities
    • 285

      System Self Test
    • 286

      Response to Ground Proximity Warnings
    • 287

      Advisory Callouts
    • 288

      Response to Terrain/Obstacle Awareness Alerts
    • 289

      Use of Terrain Awareness Display
    • 290

      System Constraints
    • 291

      Performance
    • 302

      TAS Indicators and Controls
    • 302

      TAS System Activation
    • 303

      TAS Alert Priorities
    • 304

      Tas System Self Test
  • 153

    Figure 3-20 KMH 820/KTA 810 Display Interface
  • 163

    Figure 3-21 KMH 820/KTA 810 External GPS Interface
  • 165

    Aircraft Configuration
  • 165

    Configuration Procedure
  • 165

    Post Configuration Test
  • 165

    Post Installation Configuration and Check out
  • 166

    Configuration Module Programming
  • 166

    EGPWS Configuration Instructions
  • 166

    Equipment Needed
  • 167

    Configuration String Format
  • 167

    String Breakdown Explanations
  • 168

    Configuration Sequence of Events (Application)
  • 168

    EGPWS RS-232 Maintenance Port
  • 169

    Configuration Identification Selection (ID)
  • 169

    Configuration Types (Categories)
  • 171

    Air Data Input Select
  • 171

    Aircraft/Mode Type Select
  • 171

    Configuration Tables
  • 173

    Position Input Select
  • 174

    Terrain Display Select
  • 175

    Audio Menu Select
  • 175

    Input/Output Discrete Type Select
  • 176

    Altitude Monitor Options
  • 176

    Audio Output Level
  • 177

    Attitude and Heading Select
  • 177

    Terrain Display Alternate Pop up Option
  • 178

    Attitude and Heading Type
  • 178

    Display Option Select
  • 179

    Display Option Type
  • 179

    TAS Configuration Options
  • 182

    TAS RS-232 Maintenance Port
  • 182

    TAS RS-422 Data Recorder
  • 183

    EGPWS Ground Test Procedures
  • 183

    Ground Test Procedures
  • 183

    Required Testing Equipment
  • 188

    Perform the Ground Test
  • 198

    Using the BFG TT391 Flightline Tester
  • 198

    Using the IFR-201 Ramp Test Set
  • 199

    TAS Bearing Accuracy Is Required for STC Approval
  • 202

    Perform Bore Sight Top/Bottom Antenna Procedure