Table of Contents
Advertisement
B
5.1 Snapshot View
On the I/O Data menu, click Snapshot View to request a snapshot (one time) of the
I/O Data. The TAS unit sends the data to the "Main Diagnotic Window".
5.2 Continuous View
On the I/O Data Menu, click Continuous View to request continuous updates of
the I/O data. Continuous mode is the single snapshot repeated every one to two
seconds. The TAS unit sends the data to the "I/O Continuous Window". A slight
screen flicker will be noticeable as each new screen of data is written.
The red Stop button on the button bar will be enabled as long as communications
are on going and the window is being updated. To stop the update, click the Stop
button.
6.
Inspecting TAS Unit's Internal Diagnostic and Log Data
On the Diag Log Menu, click View Log to request the TAS unit's Internal Diagnotic
and Log Data. The TAS unit sends the data to the "Main Diagnostic Window" ( see
Figure
3.)
Rev 3, August/2002
10609I03.CDL
KMH 880/KTA 870
D-9
Advertisement
Table of Contents
