Table of Contents
Advertisement
B
For new installations of Equipment or the Configuration Module, use the "Initial-
ize Config Mod" option
4.2.3 EGPWS Configuration Instructions
These instructions will detail the configuration check list, initial configuration (new
configuration module) and volume output levels for the EGPWS.
It describes how the EGPWS interfaces to specific aircraft configurations. It con-
tains an overview of the selection categories for the different aircraft sensor inter-
faces. It defines how the category IDs are selected for the interface to aircraft
sensors and to select EGPWS performance options. It defines the specific aircraft
applications of the EGPWS.
4.2.3.1 Equipment Needed
A.
EGPWS Installed and Operating
B.
Interconnect Cable
C.
IBM or Compatible PC
D.
A Copy of Honeywell WINVIEWS
WinViews is an Enhanced GPWS diagnostic communications program that runs
from Windows on a PC that is connected to the EGPWS. WinViews HELP, as
well as many other menu items are active even though the program is fully oper-
ational when communications are established with the EGPWS.
4.2.3.2 Configuration Module Programming
The Configuration Module Programming is completed via the RS-232 port.
The application code is capable of loading the Configuration Module with new
data.
This programming is achieved by using the WinsViews software. In WinViews,
the EGPWS will accept valid commands. To prevent inadvertent access to the
Configuration Module's EEPROM, the keyboard monitor is set up with a tiered
menu. The keyboard monitor command "CFG" is used to gain access to the
Configuration monitor.
The command to program the memory with the Configuration String is
"CUW".
Rev 3, August/2002
NOTE
(see Appendix D, Section
NOTE
10609I03.CDL
KMH 880/KTA 870
7.6).
Page 4-2
Advertisement
Table of Contents
