Table of Contents
Advertisement
B
B
B
B
2.0
INTRODUCTION
This section contains suggestions and factors to consider before installing the KMH 880/
KTA 870 System. Close adherence to these suggestions will assure satisfactory perfor-
mance from the equipment.
The conditions and tests performed on the system components are mini-
mum performance standards. It is the responsibility of those desiring to
install the KMH 880/KTA 870 either on or within a specific type or class of
aircraft to determine that the aircraft installation conditions are within the
TSO standards. The KMH 880/KTA 870 may be installed only if further
evaluation by the applicant documents an acceptable installation and is
approved by the administrator.
2.1
UNPACKING AND INSPECTING EQUIPMENT
Exercise extreme caution when unpacking equipment. Perform a visual inspection of the
unit for evidence of damage incurred during shipment. If a damage claim must be filed,
save the shipping container and all the packing materials to substantiate your claim. The
claim should be filed as soon as possible. The shipping container and all packing mate-
rial should be retained in the event that storage or re-shipment of the equipment is nec-
essary.
2.2
EQUIPMENT INSTALLATION
2.2.1 General
The following paragraphs contain information pertaining to the installation of the
KMH 880/KTA 870 System, including instructions concerning location and mount-
ing of the antennas.
The equipment should be installed in the aircraft in a manner consistent with
acceptable workmanship and engineering practices, and in accordance with the
instructions set forth in this publication. To ensure the system has been properly
and safely installed in the aircraft, the installer should make a thorough visual
inspection and conduct an overall operational check of the system, on the ground,
prior to flight.
Rev 0, October/2000
SECTION II
INSTALLATION
NOTE
10609I00.ZIPCDL
KMH 880/KTA 870
Page 2-1
Hide quick links:
Advertisement
Chapters
Table of Contents
