Visual Annunciate Traffic (Lamp Output); Synthesized Voice Output - Honeywell BENDIX KING KMH 880 System Installation Manual

B B
B B
3.1.8

Visual Annunciate Traffic (Lamp Output)

The "Visual Annuciator Traffic" output is activated whenever a traffic advisory is
issued. This output will remain in the activated state for the duration of the
advisory unless cancelled or inhibited.
ACTIVE = GROUND ( < 10 ohms to ground), VOLTAGE 0 to +3.5 VDC.
INACTIVE = OPEN
Current Capability = 200 milliamps., when activated.
Voltage Capability = +36 VDC, when not activated.
J10-24 VIS_ANNUN_TRAFFIC*
3.1.9

Synthesized Voice output

KMH 820/KTA 810 will supply low level audio signals of up to 100 milliwatts at
1000 Hz into a 600 ohm audio distribution system. The outputs are on pins
"PH_HI" and "PH_LO".
J 10-20 = PH_HI
J 10-21 = PH_ LO
The power output will be adjustable based on the audio level inputs.
The TAS messages available for output are as follows:
1. "TAS System Test OK"
2. "TAS System Test Fail"
3. "Traffic, Traffic"
4. "Traffic"
A 1 kHz tone is available for calibration adjustments only.
Page 3-8
NOTE
10609I00.ZIPCDL
KMH 880/KTA 870
Rev 0, October/2000