Setting The Sewing Foot Lifting Height - DURKOPP ADLER M-type 867 Service Instructions Manual

Sewing feet

12.4 Setting the sewing foot lifting height

When the pedal is pressed back halfway, the sewing feet can be raised
during sewing, e.g. to move the material being sewn.
When the pedal is pressed completely back, the sewing feet will be raised
after the thread is cut so that the material being sewn can be exchanged.
Proper setting
The distance between the raised sewing feet and the throat plate is preset
to 25 mm on delivery.
Fig. 45: Setting the sewing foot lifting height
Setting steps
1. Loosen the counternut (2) for the adjusting screw (1).
2. Turn the adjusting screw (1) to set the distance between the raised sew-
3. Tighten the counternut (2) for the adjusting screw (1).
Service Manual 867 Version 02.0 - 04/2015
WARNING
Risk of injury
The sewing machine must remain switched on so
that the sewing feet can be raised.
Work very carefully when you check and set the lift-
ing height for the sewing feet.
Do not put your hands under the sewing feet when
they are being lowered.
(1) - Adjusting screw
(2) - Counternut
ing feet and the throat plate:
• To raise the sewing feet to a lesser height: Turn it clockwise
• To raise the sewing feet higher: Turn it counterclockwise
57