Table of Contents
Advertisement
Sewing foot lift
6. Turn the machine head to the looping stroke position.
The lever (1) must make a movement.
7. Loosen both threaded pins on the eccentric (3).
8. Rotate the eccentric (3) on the arm shaft.
9. Tighten both threaded pins on the eccentric (3).
10. Turn the arm shaft and check that the lever (1) makes a movement.
9.5 Adjusting the sewing foot height
The sewing foot height can be set electronically from 1 mm to a maximum
of 10 mm.
Proper setting
If a height of 1 mm is set in the control, the sewing foot must be 1 mm
above the throat plate.
To adjust the height of the sewing foot:
1. Assemble the jumping foot.
2. Press Extras > Service > Multitest (Multi test) > Hublage
3. Press Hüpfer/Drücker (Jumping foot/presser foot) until
4. Press Nähfuß-Hub (Sewing foot stroke).
5. Enter a sewing foot height of 1.0 mm.
6. Move to position.
7. Turn the sewing foot to bottom dead center.
The distance between the throat plate and sewing foot must be
Fig. 32: Adjusting the sewing foot height
(1) - Nut
(2) - Screw
8. Loosen the screw (3).
Service Instructions 911-210-10 - 00.0 - 06/2020
einstellen (Set stroke position).
the jumping foot is selected.
1 mm.
①
②
③
(3) - Screw
45
Advertisement
Table of Contents
