16.3 Setting the thread-pulling knife
Fig. 62: Setting the thread-pulling knife
①
②
③
(1) - Thread-pulling knife
(2) - Counter-blade
(3) - Marking
(4) - Knife carrier
(5) - Roller
Proper setting
• When the thread-pulling knife (1) is at rest, the distance between the
• The control cam (7) makes contact with the clamping ring (6)
• The marking (3) on the thread-pulling knife (1) is adjacent to the cutting
• The knife carrier (4) must have no axial play, but still run smoothly
76
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp and moving parts.
Switch the sewing machine off before you check
and set the thread-pulling knife.
NOTICE
Risk of breakage
Never operate the machine without the thread-pulling knife.
The reverse-motion lock for the bobbin housing is on the thread-
pulling knife.
highest point of the control cam (7) and the roller (5) is 0.1 mm
edge of the counter-blade (2)
④
⑤
⑥
(6) - Clamping ring
(7) - Control cam
(8) - Lever
(9) - Clamping ring
(10) - Screw
Service Manual 867 Version 02.0 - 04/2015
Short thread cutter (KFA)
⑩
⑨
⑧
⑦