Fig. 14: Setting the upper toothed belt wheel
Setting steps
1. Using the screwdriver, push the toothed belt (4) as far to the side until
2. Loosen the setscrews (2).
3. Turn the upper toothed belt wheel (1) such that the setscrews (2) are
4. Additional setting step for machines with normal lengths
Machines with
normal lengths
5. Tighten the setscrews (2).
6. Use the screwdriver to push the toothed belt (4) back again.
24
(1) - Upper toothed belt wheel
(2) - Setscrews
(3) - Winder wheel (position in machines
with normal lengths)
the two setscrews (2) can be reached.
seated completely on the surface (5) of the arm shaft.
Move the upper toothed belt wheel (1) to the side such that the distance
to the winder wheel (3) is 0.8 mm.
Positioning the toothed belt wheels
(4) - Toothed belt
(5) - Surface of arm shaft
Service Manual 867 Version 02.0 - 04/2015