Xerox DocuColor 12 Getting To Know Manual page 15

Clearing jams behind the front door
Demonstrate opening the front door on the printer.
See Figure 18.
Be careful. The fuser is hot and you may
!
get burned.
Point out the access areas inside the printer used for
jam clearance. See Figure 19.
1. Rotate the green latch handle clockwise and pull
out the paper path module until it is fully open.
2. Lift the baffle (marked 1) and remove jammed
paper. Press the baffle gently back into place.
3. Remove any paper from the entry to the fuser.
4. Push the green handle (marked 2) to the right
and remove any paper from the exit area of the
fuser. Gently secure the handle back into place.
5. Lower the green handle (marked 3) and remove
any paper from the aligner baffle.
6. Lower the green handle (marked 4) and remove
any paper from the duplex in baffle. Gently
secure the handle back into place.
7. Push the paper path module firmly into the
printer and rotate the green latch handle coun-
terclockwise to latch it.
Getting to Know Your Product
Product Orientation Guide
Figure 18
3
2
5
1
7
Figure 19
4
6
11