Compression Control Protocol (Ccp) - ZyXEL Communications Omni TA128 User Manual

form by CHAP. Sometimes CHAP can not be supported by the ISP.
You may set S87.2=1 to use PAP only. If you do not want to do
authentication at all, set S118.3=1 to disable the conversion.
O
Disabling authentication may cause problems in Windows
:
NOTE
95.
CHAP is described in RFC1994 and PAP is described in RFC1334.
The only hash method supported by CHAP is MD5, MS-CHAP isn't
supported yet. At this time authentication conversion works for
clients only.
Related commands:
• ATS118.3 = 1 - Disable authentication conversion.
• ATS118.3 = 0 - Enable authentication conversion depends on
S87.2 (default).
• ATS87.2 = 1 - Accept PAP/None only.
• ATS87.2 = 0 - Accept CHAP/PAP/None (default).

Compression Control Protocol (CCP)

The ISDN channel can be utilized more effectively when using
compression. Compression Control Protocol (CCP) is used by PPP
to negotiate compression methods between peers. CCP starts after
the PPP reaches the network phase. Both ends must support the
same compression method to start packet compression. ZyXEL
supports STAC/LZS. Right now STAC/LZS is only supported with
single history check mode 0 (none), 3 (sequence) and 4 (extended).
Mode 1 (LCB) and mode 2 (CRC) are not supported due to patent
limitations. CCP negotiation is described in RFC1962. STAC/LZS is
described in RFC1974. The TA will monitor the DTE's activity. If
software compression has been negotiated, the TA will automatically
disable STAC/LZS compression.
Related commands:
• AT&K00 - Disable CCP negotiation (default).
38