Setting The Ringer Level - Icom IC-F29DR Operating Instructions Manual

4
SETTINGS

Setting the ringer level

You can adjust the ringer level between 1 and 5,
or 1 (Linked) and 5 (Linked). When a linked option
is selected, the ringer audio level is adjustable by
rotating [VOL].
NOTE:
Turn ON the Beep function (p. 7) before you start
setting the ringer level.
1) Rotate [VOL] to turn OFF the transceiver power.
2) Set [Rotary Selector] to Channel 16.
3) While holding down [Lower], rotate [VOL] to
turn ON the power and enter the Ringer Level
Adjustment mode.
• A n opening beep sounds and "Sixteen" will be
announced.
4) Push [Upper] to increase, or push [Lower] to
decrease the ringer level.
• A beep sounds after pushing [Upper] or [Lower].
NOTE:
• R epeatedly pushing [Upper] first selects 1 (lowest)
to 5 (highest), and then selects the lowest linked
level, 1 (Linked) to the highest, 5 (Linked).
Repeatedly pushing [Upper] or [Lower] repeats the
cycle. See the illustration to the right.
• T he adjustable range is 1 to 5 or 1 (Linked) to 5
(Linked).
• A beep sounds after pushing [Upper] or [Lower].
Therefore, you can determine the current level
setting by the increasing or decreasing loudness of
the beep that sounds.
• T o determine if you have selected a linked level,
set [VOL] to minimum, then push [Upper] up to
10 times, listening for the loudest beep (level 5).
Pushing [Upper] once after the loudest beep will
select 1 (Linked). Repeatedly push [Upper] or
[Lower] to select the desired linked level.
5) Rotate [VOL] to turn OFF the power and exit the
Ringer Level Adjustment mode.
[Rotary Selector]
[Upper]
[Lower]
10
[VOL]
Pushing Pushing
[Upper] [Lower]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)