Setting The Ringer Level - Icom IC-V10MR Operating Manual

2
BASIC OPERATION

■ Setting the Ringer level

The Ringer level can be adjusted between 1 and 5, or 1
(Linked) and 5 (Linked). When a Linked option is selected,
the Ringer level is adjustable by [VOL].
Rotate [VOL] to turn the transceiver power OFF.
q
[ROTARY SELECTOR] to Channel 16.
Set
w
While holding down
e
power and enter the Ringer level adjustment mode.
Push [Upper] to increase, or push [Lower] to decrease
r
the Ringer level.
• The adjustable range is 1 to 5 or 1 (Linked) to 5 (Linked).
• If the level is set at 1 to 4, pushing [Upper] increases the level and
pushing [Lower] decreases the level. If the level is at 5, push-
ing [Upper] selects the linked levels, starting with 1 (Linked). If
the level is at 1 (Linked) to 4 (Linked), pushing [Upper] increas-
es the level and pushing [Lower] decreases the level. If the level
is at 5 (Linked), pushing [Upper] returns the level to 1. Repeat-
edly pushing [Upper] or [Lower] repeats the cycle.
• A beep sounds after pushing [Upper]. Therefore, you can de-
termine the current level setting by the increasing loudness of
the beep that sounds.
• To determine if you have selected a linked level, set [VOL] to
minimum, then push [Upper] up to 10 times, listening for the
loudest beep (level 5). Pushing [Upper] once after the loudest
beep will select 1 (Linked). Repeatedly push [Upper] or [Low-
er] to select the desired linked level.
13
[Lower], rotate [VOL] to turn ON the
Rotate [VOL] to turn the power OFF, then ON again to exit
t
the beep level adjustment mode.
NOTE: This operation may not be selectable, depending
on the presetting. Ask your dealer for details.
[ROTARY SELECTOR]
[VOL]
[Upper]
[Lower]
[Upper] [Lower]
operation operation
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)