Setting The Ringer Level - Icom IC-F29SR2 Operating Manual

4
SETTINGS

Setting the ringer level

You can adjust the ringer level between 1 ~ 5, or
1 (Linked) ~ 5 (Linked). When a linked option is
selected, the ringer audio level is adjustable by
rotating [VOL].
NOTE: Turn ON the Beep function before you start
setting the ringer level. (p. 6)
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [ROTARY SELECTOR] to Channel 16.
3. While holding down [Lower], rotate [VOL] to turn
ON the transceiver and enter the Ringer Level
Adjustment mode.
• An opening beep sounds and "Sixteen" is announced.
4. Push [Upper] to increase, or push [Lower] to
decrease the ringer level.
• A beep sounds after pushing [Upper]. Therefore,
you can determine the current level setting by the
increasing loudness of the beep that sounds.
Information
L
• The adjustable range is 1 ~ 5, or 1 (Linked) ~ 5
(Linked).
•  R epeatedlypushing[Upper]firstselects1(lowest)to
5 (highest), and then selects the lowest linked level,
1 (Linked) to the highest, 5 (Linked). Repeatedly
pushing [Upper] or [Lower] repeats the cycle. See the
illustration to the right.
• To determine if you have selected a linked level,
set [VOL] to minimum, then push [Upper] up to 10
times, listening for the loudest beep (level 5). Pushing
[Upper] once after the loudest beep will select 1
(Linked). Repeatedly push [Upper] or [Lower] to select
the desired linked level.
5. Rotate [VOL] to turn OFF the transceiver and exit
the Ringer Level Adjustment mode.
[ROTARY SELECTOR]
[Upper]
[Lower]
8
[VOL]
Pushing Pushing
[Upper] [Lower]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)