Setting The Ringer Level - Icom iF3200DEX series Operating Instructions Manual

3
BASIC OPERATION

Setting the ringer level

You can adjust the ringer level between 1 and 5, or 1
(linked) and 5 (linked).
When a linked level is selected, you can adjust the ring-
er level by rotating [VOL].
Rotate [VOL] to turn OFF the transceiver power.
q
Set [ROTARY SELECTOR] to Channel 16.
w
While holding down [Lower], rotate [VOL] to turn
e
ON the power and enter the ringer level adjustment
mode.
Push [Upper] to increase, or push [Lower] to de-
r
crease the ringer level as shown to the right.
• A beep sounds after pushing [Upper] or [Lower]. There-
fore, you can determine the current level setting by the
increasing loudness of the beep that sounds.
• To determine if you have selected a linked level, set [VOL]
to minimum, then push [Upper] up to 10 times, listening
for the loudest beep (level 5). Pushing [Upper] once after
the loudest beep will select 1 (Linked). Repeatedly push
[Upper] or [Lower] to select the desired linked level.
Rotate [VOL] to turn OFF the power to exit the ringer
t
level adjustment mode.
NOTE: This operation may not be available, depend-
ing on the presetting.
[Upper]
[Lower]
3-9
[ROTARY SELECTOR]
[VOL]
Pushing
[Upper]
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Lower]
5
4
3
2
1