Table of Contents
Advertisement
4
SETTINGS
Setting the beep and announcement level
You can adjust the beep and announcement level
between 1 and 5, or 1 (linked) and 5 (linked). When
a linked option is selected, the beep audio level is
adjustable by rotating [VOL].
NOTE:
Turn ON the Beep function (p. 7) before you start
setting the beep and announcement level.
1) Rotate [VOL] to turn OFF the transceiver.
2) Set [Rotary Selector] to any channel other than
Channel 16.
3) While holding down [Lower], rotate [VOL] to turn
ON the power and enter the Beep Level Adjustment
mode.
• A n opening beep sounds and the selected channel
number will be announced.
4) P ush [Upper] to change the beep level.
• A beep sounds every time you push [Upper].
NOTE:
• R epeatedly pushing [Upper] first selects 1 (lowest)
to 5 (highest), and then selects the lowest linked
level, 1 (Linked) to the highest, 5 (Linked).
Repeatedly pushing [Upper] repeats the cycle. See
the illustration to the right.
• T he adjustable range is 1 to 5 or 1 (Linked) to 5
(Linked).
• A beep sounds every time you push [Upper].
T herefore, you can determine the current level
setting by the increasing loudness of the beep that
sounds.
• T o determine if you have selected a linked level, set
[VOL] to minimum, then push [Upper] repeatedly,
listening for the loudest beep (level 5). Pushing
[Upper] once after the loudest beep will select 1
(Linked). Repeatedly push [Upper] to select the
desired linked level.
5) Rotate [VOL] to turn OFF the power and exit the
Beep Level Adjustment mode.
[Rotary Selector]
[Upper]
[Lower]
8
[VOL]
Pushing
[Upper]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Advertisement
Table of Contents
