Aquaquake Water Draining Function; Setting The Call Channel; Basic Operation - Icom IC-M25 Instruction Manual

AquaQuake Water Draining
function
Water in the speaker grill may muffle the sound coming
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill, by generating vibrating
the speaker.
➥ Hold down both [SCAN] and [Hi/Lo] for 1 second.
• A low vibration tone sounds for 10 seconds to drain water,
regardless of the volume level setting.
• This function also stops when a key is pushed.
NOTE: This function does not activate when an external
speaker microphone is connected.

Setting the Call channel

You can recall the most often-used channel with a single
operation, by setting the channel as the Call channel.
The Call channel can be set in each channel group.
Hold down [U/I/C] (CH/WX) for 1 second to change the
q
channel group. Repeat to go to the desired group.
Hold down [16/C] for 1 second to recall the current Call
w
channel in the selected group.
• "CALL" and the Call channel number appear.
Hold down [16/C] again for 3 seconds (until a long beep
e
changes to 2 short beeps) to enter the Call channel
setting mode.
• The channel number starts blinking.
Push [Y] or [Z] to select the new Call channel.
r
Push [16/C] to set the displayed channel.
t
• 2 short beeps sound.
• The channel number stops blinking.

BASIC OPERATION

4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
13