Table of Contents
Advertisement
In viewing mode, the receiver will notify you 10 seconds before a timer starts. You can confirm the timer
by pressing ok or you can cancel it with ExIT. If there is no input given, the timer will be executed. After
the timer event has been finished, the receiver switches to the channel which was watched before. If the
receiver was in standby, it automatically turns to standby again after the timer passed.
If you already have timers in the list you can use these functions as well:
Edit:
Delete:
After your settings have been made as you like, you can leave the menu with ExIT.
6.4.2 Information
In the Information menu you can get information about the hardware and software version installed in
your receiver as well as further information about our website: www.strong.tv. Please open this menu
when you call our hotline or contact the support. The person who answers your call/email might ask for
the information given in this screen.
6.4.3 change password
In order to access certain functions of the receiver you need to enter a PIN code. This is done to prevent
changes of the receiver settings through persons who do not know the PIN code (e.g. children).
To change the PIN code to a new one it is required to enter your old (current) PIN (DEfaUlT pIn: 0000)
by using 0-9 to enter, then enter the new PIN code and confirm it again.
6.4.4 Updating the software by Usb
This feature allows you to upgrade receiver software via the USB port. When new software is available for
your receiver, it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) into the root directory of your USB storage device (HDD, memory
stick etc.) and insert this device into the USB port of the receiver. Please consider that only USB devices
formatted in FAT or FAT32 file system will be detected and can be used for the update process.
Now select Upgrade by USB via the p/q buttons and press ok to proceed. If the USB device is detected
successfully, you'll be asked to enter your PIN code (DEfaUlT pIn: 0000). The receiver will enter the
update process now and the progress information will be shown. Please wait until the update is finished!
After the update is completed, the receiver will reboot automatically.
WaRnIng:
After the update the receiver restarts automatically! During this process NEVER
disconnect the receiver from the main or switch power OFF! This can damage your
receiver and warranty will void!
6.4.5 software update via terrestrial signals
Your receiver is able to update software through the digital terrestrial broadcast as well. Whether there is
a software version broadcasted in your area can be found out via your local support or dealer.
When you know that there currently is an update available, enter the menu OAD Upgrade in the Tools
menu and press ok to continue. The further steps will be shown on screen. Please read the instructions
carefully to update your receiver successfully!
During the update a progress banner will be displayed for your reference.
WaRnIng:
During the update process NEVER disconnect the receiver from the main, switch power
OFF or disconnect the antenna cable! This can damage your receiver and warranty will
void! After the update has been finished the receiver restarts automatically!
14
If you wish to change some settings for an already present timer, use p/q to
select the timer and press gREEn to open this timer. Afterwards you can define
the settings like described in above.
For deleting a timer you don't need anymore use the p/q buttons to select the
desired timer and press blUE to delete it. A message will be shown where you can
press ok to confirm deletion or press ExIT if you wish to keep the timer.
Advertisement
Table of Contents
