Table of Contents
Advertisement
Operating the Forum IPhone 512
Note:
If the administrator has linked a trunk key
user account, you will be calling under the call number of the
SIP user account. If the trunk key is not linked, the call number
of trunk key 1
Answering a Call
An incoming call is signalised via ringer, a blinking trunk key and the blinking
red LED indicator to the upper right:
To accept the call, you:
●
pick up the handset or
●
press the blinking trunk key
●
press the loudspeaker key
handsfree mode (see page 16).
Accepting a Call While Telephoning
You are telephoning, e.g. on trunk key 1
see the call on the display. The LED next to your available trunk key, e.g.
is blinking.
1. Press the trunk key where the caller is waiting. The other caller is put on
hold. You talk with the caller.
2. You can also toggle back and forth between callers or initiate a conference
with both callers (please refer to page 15 also).
3. Press the goodbye key
trunk key where the other caller is waiting. You are now connected with the
caller on hold once again.
Note:
If you have switched on call waiting protection (please refer to
page 17 also) no other calls will be signalled (no call-waiting
tone, no LED of an available trunk key blinking). Callers now
receive the busy signal.
12
is used.
/
or
to accept the following call in the
, hear the call-waiting tone and
to terminate the current call. Then press the
Telephoning
/
with a SIP
,
Advertisement
Table of Contents
