Recutting The Valve Seats - Husqvarna 2009 TE 310 Workshop Manual

Recutting the valve seats

Clean carbon and deposits from the valves. Apply some "Prussian blue" to the
valve face and lap it against the seat with a suitable lapping tool. Remove the
valve and measure the width "X" of the contact surface. If the width exceeds
0.06 in. the seat should be recut.
Standard width of the contact surface is:
A = 0.0354÷0.0433 in. for the INTAKE
A = 0,0354÷0,0394 in. for the EXHAUST.
The valve can not be ground. If the valve is damaged replace the
valve.
INTAKE
EXHAUST
Part. N. 8000 H0368 (09-2008)
ENGINE OVERHAULING
ø 250-310
30,10÷30,15 mm
B
1,185÷1,187 in.
27 mm
C
1,063 in.
24,60÷24,65 mm
B
0,968÷0,970 in.
21,5 mm
C
0,846 in.
G.3
450-510
36,60÷36,65 mm
1,441÷1,443 in.
33 mm
1,299 in.
30,60÷30,65 mm
1,205÷1,207 in.
27,5 mm
1,083 in.