Reassembly Of Counter Balancing Shaft Driving Gear (Smr 450-510) - Husqvarna 2009 TE 310 Workshop Manual

Hide thumbs Also See for 2009 TE 310:
Table of Contents

Advertisement

Using a depth slide gauge, measure height "B" between the bearing and joint face on the two crankcase halves. Measure width "A" of the
crankshaft. Taking into account that the play between crankshaft and base has to be 0.4 mm - 0,0157 in., shim washer "C" thickness to be
used is given by difference:
Shim washers are available in the following thicknesses:
0,3 mm - 0.0118 in.(code no.: 8A0028183)
0,5 mm - 0.0197 in.(code no.: 8C0028183)
0,6 mm - 0.0236 in.(code no.: 8D0028183)
0,8 mm - 0.0315 in.(code no.: 8F0028183)
1,0 mm - 0.0394 in.(code no.: 8H0028183)
ENGINE REASSEMBLY

Reassembly of counter balancing shaft driving gear (SMR 450-510)

Put the flywheel on the press as shown in picture (with the left half-flywheel surface
on the press plane) and assemble the layshaft driving gear (2) on the flywheel (use
a 4 mm - 0.16 in. pin (1) for correct assembly as shown in the picture). Remove pin
after assembly.
C=["B" (on both sides)] - ("A" + 0.4 mm)
H.16
REFERENCE (3) OUTWARD
* On L.H. Side
Part. N. 8000 H0368 (09-2008)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents