Discharge Of Hydraulic System Fluid; Overhaul Of The Control Pump For Clutch Release - Husqvarna 2009 TE 310 Workshop Manual

HYDRAULIC CONTROL CLUTCH

Discharge of hydraulic system fluid

Connect a small plastic hose to the discharge valve and unscrew it by one or two
turns. Remove the reservoir cover and the diaphragm and act release control
lever until all fluid is discharged.

Overhaul of the control pump for clutch release

Drain the system, detach the pump from the L.H. side of the handlebar and
disassemble the pump completely. Replace all gaskets, re-assemble the pump
and assemble it again on the handlebar. Connect the hose and pour new fluid
from the tank; bleed the system as shown on page P.5.
P.4 Part. N. 8000 H0368 (09-2008)