Husqvarna 2009 TE 310 Workshop Manual page 210

FRONT SUSPENSION
• Push the pre- assembled pumping element ( 23 ) until it is in contact with the
stanchion tube ( 5 ).
• Tighten the bottom valve by hand.
• Insert the R5081AA tooling inside the fork leg in a way that you can block the body
rotation; to do so, the slot obtained at the tooling bottom edge must be perfectly
inserted into the body hexagon.
WARNING
In the tooling upper part there are two opposite holes where you can
insert an axle to make blocking easier. However, the tooling must not be
rotated in any case, but only used to hold the fork leg inner parts.
2 3
5
• Using a 21 mm tube wrench tighten the bottom valve ( 41 ) up to the required torque
(see Table 1 - Tightening Torques).
4 1
I.20
Part. N. 8000 H0368 (09-2008)