Husqvarna 2009 TE 310 Workshop Manual page 343

6- Turn signals KIT (TE)
FRONT TURN SIGNALS
Remove the upper fastening screw of the the headlamp carrier to the instrument
panuel support (A);
- push forward the headlamp carrier (B) and pull it towards the high (C) in order
to uncouple from the two lower supports.
- remove the headlamp carrier.
Assemble the turn signal (1) on the plate (5) tightening it with the nut (10).
Remove the front fork steering head fastening screws (D) and assemble the
plate complete with turn signal using the same screws (D) and the spacer (7)
(R.H. side: remember to assemble the horn E between the turn signal plate
and the spacer on the front fork steering head). Connect the turn signals to the
main wiring harness (see the wiring diagram on page O.13). The description
refers to the assembly of the left turn signal (1), the assembly of the right turn
signal is symmetrical.
Part. N. 8000 H0368 (09-2008)
"KIT" ASSEMBLING INSTRUCTIONS
O.11
1- L.H. front turn signal (no. 1 piece)
2- R.H. front turn signal (no. 1 piece)
3- L.H. rear turn signal (no. 1 piece)
4- R.H. rear turn signal (no. 1 piece)
5- L. H. front plate (no.1 piece)
6- R. H. front plate (no.1 piece)
7- Front spacer ø8,5xø16x3 mm (no. 2 pieces)
8- Screw M6x16 mm (no. 2 pieces)
9- Screw M6x20 mm (no. 2 pieces)
10- Nut M6 (no. 4 pieces)
11- Bushing ø7xø9x4,8 mm (no. 2 pieces)
12- Turn signal flasher (no.1 piece)