Husqvarna 2009 TE 310 Workshop Manual page 341

"KIT" ASSEMBLING INSTRUCTIONS
6- Blinkers Kit (SMR)
FRONT TURN SIGNALS
Remove the upper fastening screw of the the headlamp carrier to the
instrument panuel support (A);
- push forward the headlamp carrier (B) and pull it towards the high (C) in
order to uncouple from the two lower supports.
- remove the headlamp carrier.
Assemble the turn signal (1) on the plate (4) fastening with the nut (6) M6, then
pass the cable (B) trough the plate front hole. Remove the steering head fastening
screws (B) and assemble the plate complete with turn signal using the same
screws (4) and the corresponding spacer (5) (R.H. side: remember to assemble
the horn (C) too, between the turn signal plate and the steering head). Connect
the turn signals to the main wiring harness. Regarding the correct connection to
the main wiring harness, see the wiring diagram (page O.13).
The description refers to the assembly of the left turn signal (1), the
assembly of the right turn signal is symmetrical.
BLINKERS KIT
1- Front left and rear right turn signal (2)
2- Rear left and front right turn signal (2)
3- Front right plate (1)
4- Front left plate (1)
5- Front spacer ø12xø20x8,5 (2)
6- Nut M8 (4)
7- Elastic washer (4)
8- Flasher
C
5 B
3
1
6
7
B
5
4
Part. N. 8000 H0368 (09-2008) O.9