Husqvarna 2009 TE 310 Workshop Manual page 407

FRAME AND WHEELS
Removing the rear wheel
Set a stand or a block under the engine and see that the rear wheel is lifted from
the ground.
Unscrew the nut (1) of the wheel pin (3) and extract it. It is not necessary to
unloose the chain adjusters (2); in this way, the chain tension will remain
unchanged after the reassembly. Extract the complete rear wheel, by taking care 1
of the spacers located at the hub sides. To reassemble, reverse the above
procedure remembering to insert the disc into the caliper.
: Do not operate the rear brake pedal when the wheel has been removed;
this causes the caliper piston to move outwards.
: After removal, lay down the wheel with brake disc on top.
2
: After reassembly, pump the brake control pedal until the pads are against
the brake disc.
TIGHTENING TORQUES
1: 142.1 Nm/ 14.5 Kgm/ 104.8 ft-lb
Part. N. 8000 H0368 (09-2008) Y.11