Troubleshooting - York Fitness 52049 Owner's Manual

Troubleshooting

If you have a problem with your cross trainer, before you do anything else please check that all
the cables have been connected correctly. Loose cables are very common and many problems
can be solved by making sure the cables are properly connected.
The following table details the most common problems and how to fix them. If you still have a problem
after going through the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM
NO DISPLAY
NO SPEED DISPLAY
PARTIAL DISPLAY
NO PULSE SIGNAL
ERROR CODE: E1
ERROR CODE: E4
ERROR CODE: E5
FOR YOUR OWN SAFETY, DO NOT OPEN PROTECTIVE CASING. IF ERROR PERSIST,
PLEASE CONTACT YOUR LOCAL YORK DISTRIBUTOR FOR ADVICE. KEEP THE
EQUIPMENT OUT OF USE UNTIL IT IS REPAIRED.
If you are having problems with your heart rate reading, please note that some fibres used in
clothes eg) polyester, create static electricity that may prevent a reliable heart rate reading. Mobile
phones, TV's, microwaves and other electrical appliances that generate an electromagnetic field
may also interfere with heart rate measurement.
CAUSE
No power
System halted
Wires are damaged or not connected properly Verify all wires are connected properly
Speed sensor is too far from magnet
The PA board is not connected properly
Wires are damaged or not connected
properly
Too much hand movement
Palms too wet
Hand Pulse Sensor is being gripped too tightly
User is wearing rings
Indicate the console have not receive the body fat figure , Make sure the user have hold
onto the handgrip sensor. Hold two hands together during training period.
Indicate the user's age, height, weight figure have exceed of the setting range when user
setting their information.
Check the console together with the stage's 12PIN connect cable, to see if the console
are bad contact or get loose with the stage's 12PIN connect cable. Check the Motor
distance have exceed of the setting range or not.
www.yorkfitness.com
CORRECTION
Make sure power cord is plugged in
properly
Unplug and re-plug the power cord to reset
the system
Contact your local YORK distributor
Unplug and re-plug the power cord
Verify all wires are connected properly
Disconnect and re-connect all cables
Contact your local YORK distributor
Verify all wires are connected properly
Dry palms
Grip using moderate pressure
Remove all rings
Contact your local YORK distributor
15