building, make sure that the electrical insulation must comply with applicable standards.
1.2.2 Installation Site
(1). Install the unit at a place where is strong enough to withstand the weight of the unit.
(2).
the room.
(3).
Floor type
>600
Ceiling type
>600
(4). Install the unit where the drain pipe can be easily installed.
The space from the unit to the ceiling should be kept as much as possible so as for more convenient
service.
(1). Determine the location of the hanger through the paper template, and then remove the paper template.
(2). Insert the anchor bolts into the drilled holes, and drive the pins completely into the anchor bolts with a
hammer.
(3).
a screwdriver and then open the inlet grille.
>600
>300
>600
U-Match Series DC
Inverter Service Manual
>1000
>1500
Anchor bolt
>300