Gree GUHD09NK3FO Service Manual page 123

U-Match Series DC
Inverter Service Manual
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step
Disassemble of water-
containing plate modules
Disassembly of evaporator components
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum
Step
Disassembly of evaporator
components
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly.
Step
plate sub-assy for air
sweeping fans
Disassembly of fan and motor components
Remark: Make sure that the power supply is cut off before disassembling and protect all
the parts during disassembly, especially the fastening screws for fans.
Step
1. Disassembly of front
and back scroll cases
2. Disassembly of fans
120
Illustration
Remove the water-containing plate modules.
Illustration
Unscrew the 6 screws of evaporator, 3 screws
of water groove press board and the 2 screws
of water board to remove the evaporator.
Illustration
Remove the display board, mounting support
and mounting plate of swing motor in turn.
Illustration
Press the buckle at the joints of front and back
scroll cases with hands and pull upward to remove
the front scroll case. Then remove the screws on
the back scroll case. Lift the buckle of back scroll
case with hands and remove it. (As is shown in the
graph, circle represents 2 screws on left and right.)
Unscrew the 2 screws of coupling, take out
the rotating shaft and louver, then loosen the
tighten screw of louver to remove the louver
Handling Instruction
Handling Instruction
Handling Instruction
Handling Instruction