Safety Vision Observer 4000 User Manual page 33

OBSERVER 4000 USER GUIDE
31
Speed
The Speed menu controls the speed
type (SPDL and SPDO) events.
Use the remote control to configure
the following options:
SPEED SOURCE: Select VEHICLE to
obtain vehicle speed data from the
vehicle's own speedometer, or GPS to
obtain this data from the GPS signal.
For more information about connecting
the DVR to a vehicle speedometer, please
contact Safety Vision Technical Support.
SPEED UNIT: Select MPH to use miles
per hour or KPH to use kilometers per
hour.
ALARM SETTING: Select the
following options for LOWSPEED and
OVERSPEED:
ENABLE: Select ON to enable this
SPEED event. Select OFF to disable it.
THRESHOLD: Use the number keys on
the remote control to enter the speed
at which the event is triggered.
ALARM: Select ON to enable the ALM
LED on the front of the DVR when the
THRESHOLD speed is reached and an
event is triggered. This LED continues
to flash after an event is triggered until
the configuration menus are accessed.
LOCK: Select ON to lock the video
of the recorded event when the
THRESHOLD speed is reached (not
allowing it to be overwritten).
Speed (Page 2)
SPEEDING VOICE INTERVAL: Enter the
amount of time (between 15 and 600
seconds) between which an optional
voice notification is sounded when a
Speed type alarm occurs.
SPEEDING DELAY: Enter the amount of time, in seconds,
between when the entered speed is exceeded and an alarm
actually occurs.