Alarms; Date/Time - KMC Controls FlexStat Operation Manual

Alarms

SAT 4/11 3:20 PM
COOL:
* SPACE TEMP ALARM 04/11
<AI1> SPACETEMP
HUM: 20%RH
SERVICE
PRESENT VALUE = 90.1
EXCEEDS HIGH_LIMIT
<EE1>
SPACETEMPALARM
A flashing "SERVICE" on the Home screen indicates
an alarm. To view and delete alarms, press:
1. Right to move among fields.
2. Enter to select. (Enter on Alarm Details screen to
delete the alarm.)
3. Left to go back one page.
Built-in alarms are triggered under these conditions:
• Space Temp Alarm—temperature outside the
range of 56 to 86° F for over 300 seconds.
• Space Humidity Alarm—humidity above 65%
for over 300 seconds. This is available only in
FlexStat models with a humidity sensor and a
dehumidification option selected in the Humid-
ity setup). See Humidity Setup on page
• Fan Fail Alarm—no fan status signal within five
seconds of call for fan (and Input 2 is configured
for the fan status sensor option). See Sensor Setup
on page 7.
• Low Limit Alarm (freeze stat)—space
temperature is below the adjustable (under
Damper Setup) low limit alarm temp for one
second (when configured for the economizer
option). After a low limit alarm is generated,
the fan will not run until after the FlexStat
is restarted. See Restart
FlexStat on page 16. See also
page 6.
(Up to six additional alarms may be added with
custom programming.)
NOTE: Time delays and limits can be modified in
the corresponding Event Enrollment objects
using TotalControl.
FlexStat
ALARMS
OCC:
04/11/09 08:37:56
FAN:
DELETE ALARM?
NO
YES
6.
under Resetting the
Damper Setup on

Date/Time

DATE: APR 11 2009
TIME: 1:43:59 PM
To enter date and time information (only), press:
1. Up/Down to move among entries.
2. Enter to select.
3. Right/Left to move among value fields.
4. Up/Down to increment/decrement value.
More options (such as UTC offset and daylight sav-
ing time options) are available in the (Advanced)
Date/Time menu (see page
13
DATE/TIME
8).
Operation Guide, Rev. K