Setpoints; System Setup; Trend Viewer - KMC Controls FlexStat Operation Manual

Setpoints

SETPOINTS
COOL SETPT:
HEAT SETPT: 67° F
COOL SETBACK: 80° F
HEAT SETBACK: 64° F
MIN SETPT DIFF: 2° F
DEADBAND: 2° F
DEHUM SETPT: 60 % RH
In the Setpoints menu, deadband, setbacks, and
setpoints for various values are set. (The room
temperature setpoint can also be manually changed
from the Home menu.)
To adjust the setpoints, press:
1. Up/Down to move among entries.
2. Enter to select.
3. Up/Down to increment/decrement value.

System Setup

SYSTEM ENABLE:
OCC OVRIDE (HRS): 1.0
INACTIVITY (SECS): 60
DISPLAY BLANKING: NO
To adjust the system configuration values, such as
system enable (auto, off, heat, or cool), occupancy
override time, and display inactivity time-out:
1. Up/Down to move among entries.
2. Enter to select.
3. Up/Down to increment/decrement value.
Occupancy Override on this menu is the amount of
time (in hours) a manual change in the setpoint (via
the Up and Down buttons) will be allowed to over-
ride the scheduled setpoint. When the time is set to
0, the override state will last until the next schedule
change.
NOTE: Occupancy override can also be removed
while on the Home screen by pushing the
left button, navigating to OCC, hitting Enter
twice, and changing ON to OFF. See H/C,
Fan, Occupancy, and Override on page
FlexStat
74° F
SYSTEM
AUTO
When Display Blanking is enabled (Y), the display
turns off at the same time the backlight goes off
(after reset, initial power-up, or time-out). When any
button is pressed, the display will reappear until the
time-out is reached again.
The menu/display/backlight time-out (seconds
since the last button is pushed) is set in Inactivity.
Access to the Main Menu, setpoint adjust, and
System/Occupancy/Fan override have a default
password level of User. This level can be changed for
each function to None, Operator, or Administrator
through this screen. Passwords are set in the (Ad-
vanced) Passwords menu. See (Advanced) Security
Levels and Passwords on page

Trend Viewer

1: SPACE TEMP
2: SPACE HUMIDITY
3: FAN
4: COOL 1
5: COOL 2
6:
7:
To view trend log buffers, press:
1. Up/Down to move among entries.
2. Enter to select.
Trend logs are set up in the (Advanced) Trend
menus (see page
4.
15
10.
TREND VIEWER
34
27
19
18
21
TL #1 SPACE TEMP
APR11 1:27PM, 70.3
APR11 2:27PM, 71.3
APR11 3:27PM, 71.6
APR11 4:27PM, 71.8
APR11 5:27PM, 76.3
APR11 6:27PM, 81.2
APR11 7:27PM, 82.3
11).
Operation Guide, Rev. K
Logs