Displaying The System Name; Setting The Switch's Ip Address; Figure 3-5 System Name - Edge-Core ES4308-PoE Management Manual

Displaying the System Name

You can easily identify the system by displaying the device name.
Field Attributes
• Switch Name – A name assigned to the switch system.
Web – Click System, Name.

Setting the Switch's IP Address

This section describes how to configure an initial IP interface for management
access over the network. The IP address for this switch is 192.168.2.10 by default.
To manually configure an address, you need to change the switch's default settings
(IP address 192.168.2.10 and netmask 255.255.255.0) to values that are compatible
with your network. You may also need to a establish a default gateway between the
switch and management stations that exist on another network segment (if routing is
not enabled on this switch).
Field Attributes
• DHCP Enabled – Check the box to enable DHCP. (default: enabled)
• LAN IP Address – Address of the VLAN interface that is allowed management
access. Valid IP addresses consist of four numbers, 0 to 255, separated by
periods. (Default : 192.168.2.10)
• Subnet Mask – This mask identifies the host address bits used for routing to
specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between this device and
management stations that exist on other network segments. (Default: 0.0.0.0)
• Management VLAN – ID of a configured VLAN (1-4093, no leading zeroes)
through which you can manage the switch. By default, all ports on the switch are
members of VLAN 1. However, the management station can be attached to a port
belonging to any VLAN, as long as that VLAN has been assigned an IP address.
Note:
If you cannot remember the switch's IP address, you can restore the original
settings by following the procedure described in the "Troubleshooting" section.

Figure 3-5 System Name

Web Configuration
3-9