Canon Pixma MP560 Service Manual page 67

MP560
5. MACHINE TRANSPORTATION
This section describes the procedures for transporting the machine for returning after repair, etc.
1) In the service mode, press the ON button to finish the mode, and confirm that the paper lifting plate of
the rear tray is raised.
2) Keep the print head and ink tanks installed in the carriage.
See Caution 1 below.
3) Turn off the machine by pressing the ON button to securely lock the carriage in the home position.
(When the machine is turned off, the carriage is automatically locked in place. DO NOT disconnect the
power cord until the carriage is completely locked in place.)
See Caution 2 below.
(1) If the print head is removed from the machine and left alone by itself, ink (the
pigment-based black ink in particular) is likely to dry. For this reason, keep the print
head installed in the machine even during transportation.
(2) Securely lock the carriage in the home position, to prevent the carriage from
moving and applying stress to the carriage flexible cable, or causing ink leakage,
during transportation. Make sure that the carriage is locked in place at power-off.
- If the print head must be removed from the machine and transported alone, attach the protective
cap (used when the packing was opened) to the print head (to protect the print head face from
damage due to shocks).
<5. MACHINE TRANSPORTATION>
64 / 64
TABLE OF CONTENTS