Canon Pixma MP560 Service Manual page 5

- At carriage unit
LCD language - At logic board
settings
Platen glass - At protection sheet
protection
sheet - At document bottom
(document
pressure sheet) - At scanner unit
position
adjustment
LF / Eject - At logic board
correction
- At paper feed roller
- At logic board
- At platen unit
Carriage rail - At carriage unit
position
adjustment - At carriage unit
N: New adjustment item
*1: Install the Service Tool to a pre-registered computer.
- The screws securing the paper feed motor may be loosened only at replacement of the
paper feed motor unit.
(2) Periodic maintenance
No periodic maintenance is necessary.
(3) Periodic replacement parts
There are no parts in this machine that require periodic replacement by a service engineer.
(4) Replacement consumables
There are no consumables that require replacement by a service engineer.
replacement
replacement
replacement
cover replacement
replacement
replacement
replacement
replacement
replacement
replacement
removal
To set the language to be
displayed on the LCD.
To maintain scanning
accuracy, hold the sheet
with the long side down,
then fit its upper left
corner to the platen glass
reference mark (back
left).
To correct line feeding
(LF roller diameter).
To correct line feeding
(eject roller diameter).
To set the carriage rail to
the original position prior
to removal or
replacement of the
carriage unit, put a mark
on the main chassis
before removal of the
carriage unit.
2 / 64
None. 1 min.
Perform in the user
mode.
None. 1 min.
*1
5 min.
Service Tool
Perform in the (LF
service mode. correction
and Eject
correction
is
performed
at the
same
time.)
None. 1 min.