Canon Pixma MP560 Service Manual page 11

Ink may have run [1600] U041 The following ink
out.
Ink tank not [1660] U043 The following ink
installed.
Print head not [1401] U051 Print head is not
installed, or not
properly installed.
Faulty print head
ID.
Print head [1403]
temperature sensor
error.
Faulty EEPROM [1405]
data of the print
head.
Multiple ink tanks [1487] U071 More than one ink
of the same color
installed.
Ink tank in a wrong [1680] U072 Some ink tanks are
position.
Warning: The ink [1700]
absorber becomes
almost full.
may have run out.
Replacing the ink
tank is
recommended.
tank cannot be
recognized.
(Applicable ink tank
icon)
installed. Install the
print head.
U052 The type of print
head is incorrect.
Install the correct
print head.
tank of the
following color is
installed.
not installed in
place.
--- The ink absorber is
almost full. Press
[OK] to continue
printing. Contact the
service center for
replacement.
8 / 64
of paper at error
occurrence is skipped
(not printed).
Replace the applicable
ink tank, or press the
Stop button to clear the
error without ink tank
replacement. When the
error is cleared by
pressing the Stop
button, ink may run out
during printing.
Install the applicable
ink tank(s) properly,
and confirm that the
LED's of all the ink
tanks light red.
Install the print head
properly.
Re-set the print head. If
the error is not cleared,
the print head may be
defective. Replace the
print head.
Replace the wrong ink
tank(s) with the correct
one(s).
Install the ink tank(s) in
the correct position.
Replace the ink
absorber, and reset its
counter. [See 4-2.
Service Mode.]
Pressing the OK button
will exit the error, and
enable printing without
replacing the ink
absorber. However,
when the ink absorber
- Spur unit
- Ink tank
- Carriage unit
- Print head
- Carriage unit
- Print head
- Carriage unit
- Ink tank
- Ink tank
The ink absorber
will become full
soon (service call
error).